To add data files to a fileset:
Display the Filesets window.
Click the appropriate tab for the fileset.
Click Add to display the Add data Files dialog box.
Select one or more data files (see notes below).
Click Open.
Notes:
You can only add data files of one type (file extension) to a fileset. Both Echoview calibration files (*.ecl) and HTI .smp files are an exception to this rule, see Echoview calibration files or Adding HTI .smp files to an Echoview fileset for more information.
To select multiple data files, click the first required data file and then do one of the following:
to select a range of data files, press SHIFT and click the last required data file.
to select individual data files, press CTRL and click each required data file.
You can add up to 2000 files to a fileset at a time.
Filenames (including full path) are limited to a maximum of 255 characters in length.
To remove data files from a fileset:
Display the Filesets window.
Click the appropriate tab for the fileset.
In the Data files section, select the data file(s) to be removed from the fileset.
Click Remove.
Note: If you remove all data files from a fileset and then add other data file(s), some settings on the Variable Properties dialog box (e.g. upper and lower display limits) will be retained from the first file that was added to the fileset.
About filesets
About the Filesets window
About data files
Adding GPS data
Importing data
Data file information